Take a look at theXRotor F7 Convertible Flight Controller from Hobbywing.This FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all-new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system. The XRotor F7 Convertible flight controller is equipped with STM32F722 MCU which has a powerful computing ability and fast running speed. High sensitivity MPU6500 six-axis motion sensor, built-in 5V & 12V double BEC, integratedOSD, and a pitch module.

Features

• Equipped with STM32F722 MCU which has powerful computing ability and fast runningspeed, and high sensitivityMPU6500 six-axis motion sensor.
• Supports BetaFlight, Cleanflight, Butterflight, Inva, and othermainstream FPV firmware.
• DJI image transmission system port equipped with corresponding flat cable
• Supportsbidirectional DShot digital throttle communication.
• Unique installation design and shockabsorption structure.
• On-board large capacity Flash memory chip.
• On-board 5V & 12V dual BEC circuit.
• On-board Pit Switch module.

Specifications

• Firmware: HOBBYWING_XROTORF7CONV
• FC Programming: Supported
• Programming via Betaflight/ Cleanflight-configurator
• Compatible with (Modes) PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, PROSHOT1000
• Compatible with (Transmitters) PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
• OSD Built-in
• Input Voltage:3-6S
• Gyro:MPU6500
• Voltage Monitoring Supported
• Current Monitoring Supported
• External Buzzer Supported
• LED Control Supported
• BEC 5V @ 1.5A ; 10V @ 1.5A
• Mounting Pattern: 20x20mm M3 / 30x30mm M3
• Size 32x32mm
• Weight 3.3g

Manual Download

Includes

• 1 x Hobbywing XRotor F7 3-6S 20×20 / 30×30 Convertible Flight Controller
• 1 x Soft Mounting Grommets Set
• 1 x Signal Cable
• 1 x User Manual