E8 Transmitter is a new wireless controller that was released by EMAX. It has a built-in ELRS 2.4GHz dual-band antenna and a 2.4GHz RF module. The RF module supports eight channels. The channel range is configurable and compatible with most receivers on the market. It is equipped with a wired trainer interface and simulation. The Mode of the device can switch between left and right-hand modes, and the ergonomic design can bring a good user experience paired together with a built-in battery that can be charged via USB.

Package Includes:

1 x E8 Radio Transmitter (ELRS 2.4)

Specifications:

Brand Name: EMAX

Item Name: E8 Radio Transmitter

Model: E8 (ELRS)

Weight: 260g (without battery)

Size: L*W*H=150x140x45mm

Working voltage: 3.7V-4.2V

Channel: 8 channels; all channels can be configured

External interface: Micro USB interface, 3.5mm audio interface (wired trainer interface)

Transmitting module: built-in 2.4GHz dual-frequency FPC antenna, 2.4GHz RF transmitting module

Working frequency band: 2.4GHz (2400MHz-2483.5MHz)

Maximum output power: 22dbm

Charging system: Built-in USB 5V–1A linear lithium-ion battery charging system

Gimbal Trim:

Each joystick has a corresponding Trim button. Each Trim button adjusts the direction of the corresponding joystick control. Each time it is adjusted, a beep will sound. When it is adjusted to the center position, it will make a longer beep. Please pay attention to the

sound. With joysticks centered, use the Trim buttons until the drone is steadily hovering in place.

Calibration of Joysticks:

The E8 Transmitter is pre-calibrated, but recalibration can help solve some common issues:

1. With the E8 Transmitter turned off, press the “L3-” button and the power button at the same time as the controller turns on.

2. Wait for the center indicator to light up and change from fast flashing to slow flashing, and push the joysticks of the E8 Transmitter to the maximum travel in the four directions: up, down, left, and right.

3. Press the “L3-” button, the prompt will sound, exit the calibration mode, and the E8 Transmitter will then boot up.

Regarding the Mode change and switching between left and right-hand operation instructions.