METEOR65PRO IS DESIGNED FOR EXPRESSLRS PILOT IN THISWINTER!Meteor65 Pro comes with a 35mm propeller for power improvement and a flexible flying experience. Beyond that, it has almost the same components and features asMeteor65, likeF4 1S 5A FC (2022)with b
METEOR65PRO IS DESIGNED FOR EXPRESSLRS PILOT IN THISWINTER!
Meteor65 Pro comes with a 35mm propeller for power improvement and a flexible flying experience. Beyond that, it has almost the same components and features asMeteor65, likeF4 1S 5A FC (2022)with built-inserial ExpressLRS 2.4G, Frsky, or TBS RX version, up to 350mW M03 VTX,19500KV 0802SEmotors,C03 FPV cameraetc,All aspects of performance are perfectly balanced.
Check out all ourMeteor65 Parts and Accessories, the rest of our Micro BNFs and our entire BetaFPV Collection!
Meteor65 Pro framehas the same perfect performance as the popular Meteor65 frame.The lightest lower profile 65mm frame to fit 35mm propellers. The battery slot is closer to the center of gravity for asmoother flying experience, and you will land on the motor screws instead ofthe battery.
Meteor65 Pro 2022 version is upgraded with a newmicro canopy, which reduces the influence of heat on electronics. Supports serial ExpressLRS 2.4G instead of SPI ERLS 2.4G. And the newC03 FPV cameraensures a high-quality and clear image.
Meteor65 Pro (2022) | Meteor65 Pro (2021) | |
FC&ESC | F4 1S 5A FC (2022) | F4 1S 5A FC |
RX | Serial ELRS 2.4G, SPI Frsky/PNP, TBS | SPI ELRS 2.4G |
Camera | C03 FPV Camera | C02 FPV Camera |
Motors | New 0208SE 19500KV (Ice Blue) | 0208SE 19500KV (Black version) |
Canopy | New Micro Canopy (2022) | Micro Canopy |
Tilt | 20 or 30 | 30 |
Weight | 23.01g(without battery) | 22.01g (without battery) |
Flight Time | 4.5 mins | 4 mins |
BETAFPV upgraded all Meteor Series quadcopters like Meteor65, Meteor65 Pro, Meteor 75, and Meteor85 whoop quadcopters, through the new flight controller, motors, camera, frame, canopy, etc, to provide the best whoop quadcopters for pilots.
BETAFPV exclusive designed BT2.0connector has broken through the bottle-neck of PH2.0 connector. BT2.0 connector has decreased internal resistance of connector effectively allowing more currentto betransferred, which means it supports 9A continuous current (15A burst). This means stronger power and longer flight time on 1S brushless drones while PH2.0 just supports 4.5A. You can enjoy more flight time without disturb of low voltage warningdue toreducingvoltage sag.
See the graph below of comparing the BT2.0 connector and PH2.0connector (solid pin version) in BETAFPV 1S 300mAh battery. The dischargecurrent is 9A in this test. The BT2.0 has double the time (about 2 minutes) and a 0.2v improvement in voltage sag.
The latestF4 1S 5A flight controllersare applied to all BNF versions of Meteor65 Pro. It features Serial ELRS 2.4G instead of SPI ELRS 2.4G for ELRS version compared to the previous version. The Frsky version reserves two UART ports for the available external receiver so it can be used as PNP and can be switched to Futaba SFHSS protocol through Betaflight configurator. The ESC on the new board powered by BB51 hardware in place of BB21 comes with Bluejay 96k ESC firmware, allowing0802SE 19500KV motorsto give full play to the efficiency of power. We update the gyro to BOSH BMI270 for better performance and stability since the new F4 1S 5A FC.
Meteor65 Pro (ELRS) | Meteor65 Pro (Frsky, PNP, TBS) | |
FC Inside | F4 1S 5A FC (Serial ELRS 2.4G) | F4 1S 5A FC (SPI Frsky) |
Gyro | BMI270 | BMI270 |
FC Firmware | BETAFPVF411 | BETAFPVF411RX |
UART Port | One UART Port | Two UART Ports |
External RX | Not Supported | Supported |
Note: For F4 1S 5A FC (serial ELRS 2.4G), ONLY Betaflight firmware 4.3.0 and up start to support BMI270 gyro. For F4 1S 5A FC (SPI Frsky), we recommend using BETAFPVF411RX 4.2.11 firmware and CLI dump file offered by BETAFPV.If you update the 4.3.0 and up firmware for serial ELRS 2.4G from the Betaflight official site, please flash the CLI dump file for Meteor65 Pro.
Download the FC firmware and CLI dump file forMeteor 65 Pro ELRS2.4G, Frsky, or TBS.
C03 FPV Micro Camerais 1.52g ultralight weight and a great camera for indoor micro FPV quadcopters. It features a 1200TVL definition with 1/3″ CMOS sensor, 2.1mm lens for 160 FOV, and excellent latency, which boasts high-quality, clear and sharper images through your goggles.
0802SE 19500KV Motormotor is a lightweight 1S motor, compared with the 0802 series brushless motors, it is not only significantly reduced the weight which is only 1.88g/pc but also ensures excellent performance of power and thrust. It makes the perfect dynamic balance, which gives the drone more flexibility and longer flying time.
Reviews
There are no reviews yet.