Note: The packaging in this productwill mention V2,however the software is confirmed ELRS V3.

The RP2 has a ceramic antenna, super light & small, ideal for racing. Built-in WIFI lets you upgrade firmware & configure the receiver via WebUI on PC/mobile. Low latency & high refresh rate makes it perfect for FPV & long-range flights. Also great for whoops, drones & fixed-wing models, as this nano receiver can fit anywhere! Developed by Jye Smith & the ExpressLRS team, it uses ESP8285 MCU & SX1280 RF chip.The EP2 comes with ELRS Firmware V3 pre-installed and aTCXOoscillator for solid connection & reliability.

Check out the rest of ourRC receiversandall ourRC transmitters, modules, and accessories!

Features

• TCXOoscillator for solid connection & reliability.
• ImprovedPCBdesignisbetterforheatdissipation.
• LEDon the topsideofPCB.
• Solderpadsareimprovedandeasiertosolderto.
• Open-source receiver based on ExpressLRS
• Upgraded rigid antenna with greater durability and performance

Specifications

• MCU: ESP8285
• Type: ISM
• Antenna: On Board SMT Antenna
• Bus interface: CRSF
• Power input range: 5V
• RF Chip: SX1280IMLTRT
• Maximum receive refresh rate: 500Hz / F1000Hz
• Minimum receiver refresh rate: 25Hz
• Firmware Version: ExpressLRS V3.0 pre-installed
• Signal format: ELRS
• FW Target: RadioMaster RP2 2400 RX
• Size: 13 x 11 x 7mm
• Weight: 0.55g (On Board antenna)

User Manual

• RP2Receiver User Manual

Includes

• 1 x RadioMaster RP2 V2 2.4GHz ELRS Nano Receiver – Ceramic Antenna
• 1 x User Manual