This frame has been assembled but never flown. Comes with all original hardware.

Low weight, excellent balance, easy to use, easy to service, respectable component protection, and DJI Vista ready. These were the goals of the Tooth Fairy 2. The low weight of this design will satisfy those 250g builds but it’s really designed to handle ~325g AUW 5″ to 5.21″ build. Of course you can always run past that weight like we do so it’s really up to you. We regularly carry GoPro’s on our builds.

The most unique feature of this frame is that the Vista is integrated into the structure. The entire rear standoff is the Vista. Also, the 3″ is designed with the option to usethese prop guardsif desired.

Light frames suffer from vibrational noise and resonance. These complications get worse as you increase the power of the quad. In order to improve reliability of these matters, this design has a unique vibration management arm mounting mechanism pointed out by Chris Rosser (YouTube: Chris Rosser). The mechanism introduces friction without the loss of rigidity. As a result, the 4mm arm version of this frame will be able to handle more powerful motors than it should. However because the frame does have somewhat long skinny arms, the 5mm version is STRONGLY recommended to use for any build that has motors larger than 2303 or otherwise 23mm short motors. The 5mm version should be selected for use with our 23mm tall motors.

Furthermore, there is an optional included carbon shim for ease of use withdamping grease. This shimis intended to be used with Nyogel 767a, Nyogel pg-44A or some other vibration damping grease (or tape if you wish). The point is to put the grease between the shim and the main deck so you can swap arms easily without dealing with gooey grease all over the arms. The included arm screws should fit with the shim and grease but they could be 1mm longer. You may want to acquire 12mm M2 screws if you wish. Future batches will include slightly longer screws.

Gopro and antenna mounts CLICK HERE

Specifications of each version:

5″ ToothFairy 2:

• Fits up to 5.25″ props
• ~52g built (56g with electronic mounting hardware)
• Central 20×20 and Whoop mount pattern (~25.5×25.5)
• Motor mounting: 12×12 M2 with two screw holes
• Rear 20×20 mount pattern for Vista or other items
• Nylon spacers included for 20×20 VTX board or otherwise
• 15mm build height
• All steel hardware
• Integrated Vista into frame design
• Top mounted battery
• 20mm cam mounting width
• 4mm arms, 2mm body, 1.5mm top and cam plates