The GEPRC ELRS NanoSE receiver is a cutting-edge RX, created from the ground up using the ExpressLRS open source project. With the revolutionary ExpressLRS technology, this receiver sets new benchmarks for long-range connectivity, low latency, and a maximum refresh rate of 500Hz. Operating at 2.4 GHz, the GEPRC ELRS NanoSE receiver is equipped with an Integrated SMD ceramic antenna, allowing for a smaller, lighter design while maintaining reliable signal reception. This makes it the perfect choice for drones with limited space and weight constraints.

Note: ELRS products now shipping have been pre-flashed with 2.x firmware. 2.x is not compatible with version 1.x, so you need to upgrade the transmitter to 2.x forproperfrequency matching.

Package Includes:

1x NanoSE receiver

2x Heat shrink tube

4x Silicone cableblack, red, yellow, green

1x Pin (4pin)

1x Instruction manual

1x Sticker

Features:

• Small size
• 0.4g weight
• WIFI Upgrade firmware
• ELRS open source project, remote control
• Integrated SMD Ceramic Antenna
• Maximum refresh rate of 500Hz
• The operation is simple

Binding:

1.The receiver is powered on and off for three consecutive times (within an interval of 1 second);

2.Receivers LED doing double flashing, indicating that the receiver has entered the binding mode;

3.Make the RF Tx module or radio transmitter enter binding status. Once the LED status changes to solid light, the binding is successful.

Specifications:

Size:12.1mm*10.4mm

Weight:0.4g

Chips:ESP8285,SX1281

Frequency band:2.4GHz ISM

Refresh rate:25Hz-500Hz

Input voltage:5V

Antenna:Integrated SMD Ceramic Antenna

Info: