A New Cinewhoop Design Philosophy

To date, many ducted cinewhoop frames have been needlessly heavy. Additionally, existing light cinewhoop frames dont have guarded props for flying around softer targets. Heavy frames leave you with very little room for adaptability to use the frame for your shoots whether it be increased payload capacity or the option for larger batteries. We at NewBeeDrone worked to change that.

The CinemAh Frame – The Most Versatile Cinewhoop Frame

The CinemAh frame is NewBeeDrones response to the need for a lighter and more versatile cinewhoop frame to carry a full GoPro. The CinemAh has a unique all-carbon fiber frame structure that allows for easy access to electronics while providing maximum structural strength.

Check out all our 3″ Drone Framesand therest of ourNewBeeDroneCollection.

The GoPro Mount (Not Included)

TheNewBeeDrone CinemAh cinewhoop TPU GoPro 8 and 9 mountsallow for 4 built-in angles for quick-snap adjustment from 0 deg to 22.5 deg. The capture cam mounts are 2xM2 mounting holes set 20mm apart allowing the community to design any mounting solution for any HD capture cam option.

Frame Specifications

• 2 sets of 1x1inch mounting locations
• Front 20×20 location has M3 mounting for a flight controller and ESC stack.
• Rear 20×20 location has M2 mounting for Caddx Vista with rear antenna mount.
• Camera mounting single and double screw camera mounting options.
• Note: The frame does not fit a full sized air unit.
• Prop Size: 3″ or 76mm
• Motor Mounting: 12mm diameter, 4-hole pattern
  
• Suggested Motors: 14xx 20xx
• 78g with Adjustable GoPro Hero8 mount and motor screws
• 68g without GoPro Hero 8 mount
• Downloadable 3D printed TPU snap-in ducts (x4) weigh 24g total 6g each duct

Includes

• 1 x NewBeeDrone CinemAh 3″ FPV Drone Frame

Newbeedrone3D Printed Parts Files