M10G-5883GNSS module integrates the u-blox 10th generation receiver chip M10050, and the magnetic sensor QMC5883L.It supports all L1 GNSS signals(GPS/GLONASS/Galieo/BeiDou)and can use up to 32 satellites simultaneously for navigation.

The high-gain18 x 18 x 4mmpatch antenna provides the best balance between performance and small size.

Built-inflash, parameters can still be saved when module lost power.

Check out our all ourFlight Controller Accessoriesand the rest of our MicoAir Products!

Specifications:

• GNSS Receiver:U-BLOX M10 (M10050)
• Magnetic Compass:QMC5883L
• Antenna:18x18x4mm
• GNSS System Support:GPS L1 /CA; GLONASS L10F; BeiDou B1L/B1C; Galileo E1B/C; QZSS L1 C/A/S; SBAS L1 C/A
• Concurrent:3 (GPS/BeiDou/Galileo(default) or GPS/GLONASS/Galileo), when Beidou B1L is turned off, it becomes possible to use 4 satellite systems at the same time: GPS+BeiDou(B1C)+GLONASS+Galileo
• Max Navigation rate:5Hz
• Max satelite num:32

• Input Voltage:5V
• Current:30mA
• Output Interface(GPS):UART (3.3V LVTTL)
• Interface(Compass):I2C
• UART Baudrate:115200(default)
• Output Protocol:UBX-PVT(default)
• PPS LED:Blue(Solid ON after powering on, blinking(1Hz) when GNSS get 3D fix)

Flight Controller Firmware Required

• INAV:>=5.0.0
• Betaflight:>=4.3.0
• Ardupilot:>=4.3.0
• PX4:>= 1.14.0

Physical

• Dimensions:20 x 20 x 7.8 mm
• Weight:7g
• Connector:SH1.0-6P 1.0mm pitch
• 3D-printed battery strap GPS mount

Links

• u-center
• u-center-2-user-guide
• u-blox-M10-SPG-5.10_InterfaceDescription

Package Includes:

• 1 x MicoAir M10G-5883 GNSS GPS & Compass Module